It would be extremely helpful and time-saving, if you would offer the option to adjust the settings for support, brim, raft and infill on a per-object-basis rather than just globally.
No matter how experienced one is, when it comes to complex objects with e.g. overhangs, one permanently has to do multiple prints with to see which setting gives you the best result (sometimes it is better to print without support than with, but one can't tell in advance). Printing the same object with different settings over night would save a helluvalot of time.
Of course this applies only to the same layer resolution. The ultimate solution/challenge would be to allow the same object printed in different layer resolution at once, so e.g. draft and normal at once, side by side. This will require the gantry to not only move up, but also down by a few microns (no interferences with the second nozzle to risk).
It would be extremely helpful and time-saving, if you would offer the option to adjust the settings for support, brim, raft and infill on a per-object-basis rather than just globally.
No matter how experienced one is, when it comes to complex objects with e.g. overhangs, one permanently has to do multiple prints with to see which setting gives you the best result (sometimes it is better to print without support than with, but one can't tell in advance). Printing the same object with different settings over night would save a helluvalot of time.
Of course this applies only to the same layer resolution. The ultimate solution/challenge would be to allow the same object printed in different layer resolution at once, so e.g. draft and normal at once, side by side. This will require the gantry to not only move up, but also down by a few microns (no interferences with the second nozzle to risk).